32 mm system was invented for line boring machines with multiple spindles with cutters spaced on 32 mm centers.

But with the OneFinity, you can drill your holes wherever you want. Looks great, but does not conform to 32mm system. You can do lots of configurations and the space between fronts lines up with adjacent cabinets. And the 3 mm space lines up with the adjacent cabinet.

The most important part of LR-32 is that this system is NOT just a jig for just a random shelf pins holes.

Pot and pan roll outs, add 150 +3+150 303 mm high front. Re: Festool LR32 Hole Drilling vs others. So now you have 5 drawer fronts, each 150 mm high. Now picture 5 drawer frontsneeding 3 mm space between each front. Subtract 5 mm for a little clearance between drawer front and countertop. The dado at the back is 16.5 mm wide x 2 mm deep. Spindle speed 24,000, feed rate 3000 mm / minute. With no clamps, the clearance height can be set to 2 mm, saving a lot of time.Įach gable takes about 5 minutes. Just made a special spoil board with holes placed in the right places so different size gable will still fit. You can forget about “system 32” as you can locate the holes wherever you want. The gable is the correct name for the cabinet side. I appreciate your willingness to share your expertise! What seemed like a great idea just a short time ago now appears to be a disaster in waiting.ĭoes anyone here have experience with this process? If you’ve been successful, how have you gone about the work? Bit selection? Straight plunge? Spiral? Peck? Feeds and speeds? RPM? If CNC really is a poor choice for this application that’s fine. Heat buildup, inadequate chip removal,having to spiral or peck the holes etc. Then there is a third option - CNC! I’ve read several articles that warn against drilling holes with a router. It doesn’t take too many ruined cabinet panels to make the price of these two systems seem pretty reasonable. Both are spendy, accurate, repeatable, and reliable. The two that are at the top of my list are the Festool LR32 system and the Schmitt32 system.

Verdict: Unsuccessful.I’ve spent considerable time researching System32 templates that are used with hand-held routers to drill shelf pin holes, assembly holes, and holes for System32 hardware. I very much want to get the LR-32 guide rail, the guide plate, etc etc (along with some other green items this person is selling) but definitely do not need another router at this time.įollowup and results of trying to mate DeWalt 618 and LR32 system. In this weeks video I make a custom MFT top with just the LR32 guiderail and router - no CNC, no purchased jigs or templates Enjoy MFT FestoolMFT, LR32.

If it is not that straightforward, what are the issues? because they are interchangeble and flexible (one permanently in a table lift another for separate table use and/or hand work one in an upgraded plunge base, D-handle base, etc.) So, basically, Im invested in the 618 line and. Has anyone adapted (or tried to adapt) a non-Festool router to use the guide-rail-based hole drilling system (LR-32)? If so, could you speak to the process (or impossibility) of adapting another router to be used on the hole drilling system guide plate? It seems like this should be as straightforward as attaching the guide plate to a plunge base, and there you go. Possible I already have several routers (DeWalt 618s) and a trim router. because they are interchangeble and flexible (one permanently in a table lift another for separate table use and/or hand work one in an upgraded plunge base, D-handle base, etc.) So, basically, I'm invested in the 618 line and have spare motors and bases. I already have several routers (DeWalt 618s) and a trim router.

Festool lr32 system